Corghi EM9980 Manual De Uso página 57

Position 2 adhesive weight
If the suggested application position is correct,
proceed as follows:
- press and release the LIVE
located on the weight tray (see figure 15b);
If the suggested application position is not cor-
rect, proceed as follows:
- press (and hold) the LIVE
- turn the wheel clockwise to move the laser
triangulator forwards or anti-clockwise to move
it backwards;
- release the LIVE
position
- if the ALU1 or ALU2 balancing programme is
selected, the machine will request confirma-
tion for both positions. Position 1 is indicated
in figure 15 (for a spring weight, i.e. ALU2) and
figure 15a (for an adhesive weight, i.e. ALU1)
whereas position 2 is indicated in figure 15c.
EM9980 - Operator's manual
15a
button
15b
button;
button to confirm the
Position 2
- after confirmation, the machine will automati-
cally recalculate the unbalances in correspond-
ence of the new set positions.
- It is possible to exit the LIVE environment by
pressing the
In this case the measured dimensions are NOT
confirmed and the machine will again request
confirmation, as shown in the figure.
Note: the edge acquired automatically by the
machine can be changed either by using the
button or using the
shown in figure 15.
CAUTION
If the operator changes the machine's balancing
programme at the end of the previously described
procedure, the icon
15c
button on the monitor.
button
15d
will appear, as
57
UK