Assembly Instructions - Dolmar SP-7650.4 R Manual De Instrucciones

ASSEMBLY INSTRUCTIONS

Assembling mist blower pipes
CAUTION:
Before performing any work on the mist blower, always stop the engine and pull
●
the spark plug connectors off the spark plug.
Always wear protective gloves!
●
Start the mist blower only after having assembled it completely.
●
Make sure that all the hose bands are tight after assembly.
●
NOTE:
Make the band's bolt heads come outer side when you tighten them as illustrated.
●
1. Assemble the swivel pipe (1) with the flexible pipe (2).
Tighten them with the 76 mm diameter band (3).
2. Assemble the flexible pipe with the elbow (4) of the mist blower.
Tighten them with the 100 mm diameter band (5).
3. Assemble the straight pipe (6) with the swivel pipe (1).
Align the groove of the straight pipe with the projection on the swivel pipe, and
turn the straight pipe until it clicks, and then tighten them with the 76 mm diameter
band (3).
NOTE:
The straight pipe stated above means the following three pipes and can be
●
substituted depending on your work need.
Straight pipe (long) (6)
–
Bent top pipe (7)
–
Straight pipe (short) (8)
–
When using the straight pipe (long) (6) or the bent pipe (7), use with tube (long)
(9).
When using the straight pipe (short) (8), use with tube (short) (10).
Only one or combination of the above pipes is supplied as a standard equipment
with your mist blower, which may differ from country to country.
The remaining types of pipes may need to be obtained as optional accessories.
(6)
(7)
(8)
11
(2)
(3)
(4)
(5)
(6)
(9)
(1)
(10)