Appropriate Usage; Description Of Warning Marks On Front Panel; Operation Elements And Connectors - Beha-Amprobe EV-500 Serie Manual De Usuario

APPROPRIATE USAGE

�WARNING
• The adapter may only be used under conditions and for the purposes for which it was designed.
• If the adapter is modified, operational safety is no longer ensured.
• The adapter may only be opened by an authorized service technician. Before opening the adapter it must
be disconnected from any electrical circuitry.

DESCRIPTION OF WARNING MARKS ON FRONT PANEL

1
2
Figure 1: Explanation of safety marks

OPERATION ELEMENTS AND CONNECTORS

12
1
2
3
4
EVA-500-X
Figure 2: Operational elements and
connectors of the test adapter
3
EVA-500-X
11
13
10
9
8
7
6
5
14
1
High danger of electric shock is present when PE Pre-Test
indicator lights while performing PE pre-test (see test
instructions on page 8). In this case, further testing must be
stopped immediately. Ensure a sufficiently connection of
your body to earth while performing this test.
2
Dangerous voltages are/may be present at L1, L2, L3, N and
PE terminals while the test adapter is plugged in to the
charging station. Use the test sockets for test purposes only.
Do not supply any appliance or charge an electric vehicle
via these connectors. In case of wrong wiring or error of the
charging station, terminals N and PE may present a hazard.
3
Terminals with low voltage output (approx. +/- 12V)
powered by the charging station. Terminal marked with
is connected to PE. Use for test purposes only. In the case
of wrong wiring or error of the charging station, these
terminals may present a hazard.
1
PP (Proximity Pilot) State rotary switch selector
(open, 13A, 20A, 32A and 63A)
2
PE Pre-Test warning indicator
3
PE Pre-Test touch probe
4
Measuring terminals L1, L2, L3
5
Measuring terminal N
6
Phase indicators of L1, L2, L3 terminals
7 Measuring terminal PE
8
PE Error (Earth Fault) button
9
CP Error "E" button
10
CP (Control Pilot) State rotary switch selector
(A, B, C , D )
11 CP signal output terminals - yellow terminal
(marked with ) is connected to PE
J
12
Test cable input with 7-pole male connector
13
EVC-20 test cable for EV charging station Type 2 with
socket outlet or fixed cable with vehicle connector
14
EV connector for charging stations type 2 with panel
mount socket outlet or fixed cable with vehicle
connector
4
J