Publicidad
Idiomas disponibles
Idiomas disponibles
CAUSE
Inverse polarity.
Excessively high welding current.
Defective earth connection.
CAUSE
Lack of or inappropriate gas.
Incorrect polarity.
Start-up procedure.
CAUSE
The arc is not high enough for the
equipment to detect it.
Excessively long ramp-down.
The electrode is too far away from the part on
starting the arc.
The sensitivity is too high.
ACCESSORIES
Accessories which are compatible with the equipment must always be used with the equipment. Con-
necting non-compatible or defective accessories may cause serious damage to the equipment. We re-
commend the use of SOLTER original accessories.
ASSEMBLY
ICON 1850, ICON 1855 and ICON 1870 MODELS (A1)
ICON 2050 PRO, ICON 2055 PRO, ICON 2070 DIGICEL PRO and ICON 2060 PFC PRO MODELS (A2)
ICON ELECTRIC SHEME (A3)
ICON PRO ELECTRIC SHEME (A4)
SOLTER SOLDADURA S.L.
SOLTER SOLDADURA S.L.
The arc does not ignite with electrode welding.
The arc does not ignite for TIG welding
Do not activate the ramp-off inTIG ASD mode.
In TIG ASD mode. The arc goes out immediately after lighting up.
CAUSE
Inverter ICON e ICON PRO
Inverter ICON e ICON PRO
Check the polarity for the electrode in question recommen-
ded by the manufacturer.
Check the current recommended for the electrode in use.
Check the earth connection. Clean the same if dirty or oxi-
dized.
Check the gas flow and if it is 100% Argon.
Check the polarity is torch negative.
Check the procedure is being conducted correctly.
Increase the arc.
Reduce arc height on the sensitivity.
Set to a lower time.
Place it 1 to 2 mm away.
Lower the sensitivity.
SOLUTION
SOLUTION
SOLUTION
SOLUTION
11
11
Publicidad
