Rothenberger RO AG8000 Instrucciones De Uso página 30

 Pull on the lever (15). Place the safety guard (12) in the position indicated.
 Release the lever and turn the safety guard until the lever engages.
 Pull on the (15) lever and turn the safety guard until the closed section is facing the operator.
 Make sure that the guard is seated securely: the lever must engage and you should not be
able to turn the safety guard.
Dust filter:
To fit:
 Attach the dust filter (10) as shown.
To remove:
 Holding the dust filter at the edges, raise it slightly (10) and then pull it downwards and re-
move.
Rotating battery pack:
Removing and inserting the battery pack:
Removal:
 Press the battery pack release (8) button and pull the battery pack (9) forwards.
Inserting:
 Slide in the battery pack (9) until it engages.
RO BC14/36 Charger, RO BP18/2 and RO BP18/4 battery (fig. B):
Before plugging in, check to see that the rated mains voltage and mains fre-
quency, as specified on the rating label, match your power supply.
Devices such as this one, which generate direct current, may have an effect on basic residual-
current circuit breakers. Use type F or better, with a release current of max. 30 mA.
Before commissioning the charger, ensure that the air slots are free. Minimum
distance to other objects is 5 cm.
Self-test:
 Insert mains supply plug.
The warning display (4) and the operating indicator (3) light up one after the other for approx. 1
second and the installed fan runs for approx. 5 seconds.
Battery pack:
Charge the battery pack before use (1).
If performance diminishes, recharge the battery pack.
26
Use only accessories that are covered by at least 3.4 mm by the safety
guard.
Always fit the dust filter if the surroundings are heavily
polluted (10).
The machine heats up faster when the dust filter is fitted
(10). It is protected by the electronics system from over-
heating (see chapter5.)
The rear section of the machine can be rotated 270° in three
stages, thus allowing the machine's shape to be adapted to the
working conditions. Only operate the machine when it is in an
engaged position.
ENGLISH