Rothenberger RO AG8000 Instrucciones De Uso página 32

The machine must not be allowed to draw in additional dust and shavings. When
switching the machine on and off, keep it away from dust deposits. After switching
off the machine, only place it down when the motor has come to a standstill.
Avoid switching on the machine accidentally: always switch it off when the battery
pack is removed from the machine.
In continuous operation, the machine continues running if it is forced out of your
hands. Therefore, always hold the machine with both hands using the handles
provided, stand in a safe position and concentrate.

Switching on: Push the slide switch (6)
forward. For continuous activation, now
tilt downwards until it engages.

Switching off: Press the rear end of the
slide switch (6) and release
Working instructions:
Grinding:
Press down the machine evenly on the surface and move back and forth so that the surface of
the workpiece does not become too hot.
Roughing: position the machine at an angle of 30° - 40° for the best working results.
Cutting-off:
Sanding:
 Press down the machine evenly on the surface and move back and forth so that the surface
of the workpiece does not become too hot.
Wire brushing:
 Press down the machine evenly.
RO BC14/36 Charger, RO BP18/2 and RO BP18/4 battery (fig. B):
Charging battery pack:
 Push the battery pack completely to the stop on the sliding seat (2).
The operating indicator (3) flashes.
Conservation charge:
Once the charging process has finished, the battery charger automatically switches to conserva-
tion mode.
The battery pack can remain in the battery charger and is therefore always ready for use.
The operating display (3) lights up continuously.
Fault:
● Warning display (4) lights up continuously.
Battery pack is not charged. Temperature too high/ too low. When the temperature of the battery
pack is between 0 °C and 50 °C, the charging process begins automatically.
● Warning display (4) flashes.
Battery pack is defective. Remove the battery pack immediately from the charger.
28
Always work against the run of the disc (see illustration). Otherwise there is
the danger of the machine kicking back from the cut out of control. Guide the
machine evenly at a speed suitable for the material being processed. Do not
tilt, apply excessive force or sway from side to side.
ENGLISH