Connecting Bluetooth - Proton PW953266 Manual De Funcionamiento

Introduction to Bluetooth
®
5. Perform one of the method below:
For newer phone that supports Secure
Simple Pairing (SSP):
A random 6 digit passkey will be displayed.
Com pare and confirm the passkey on
both the phone and head unit are
matched.
For classic phone:
Enter the defined PIN code when prompt
("0000" by default).
U p o n s u c c e s s f u l p a i r i n g , s y s t e m
will automatically connect with the phone.
the mobile phone will prompt for a passkey,
enter the PIN.
Notes:
Please make sure your mobile phone supports
the HFP profiles.
Always make sure the Bluetooth Operation mode
®
in the phone is on when using this car handsfree.
Any further connection attempts by other devices
to connect as HFP partner are rejected until the
current device is disconnected. Please refer your
mobile phone owner's manual for disconnecting
device.
Please refer chapter "Handsfree Operations" on
page 26 for telephone function.
Pairing with an external audio player
(A2DP support)
1. Select "ADD DEV" from Telephone Menu
mode.
2. "PAIRING" is displayed.
3. Set the Bluetooth audio player in Pairing
®
mode.
Wireless Technology
4. The display returns to previous mode after 2
seconds.
Notes:
Please make sure your external audio player
supports the A2DP and AVRCP profiles.
Any further connection attempts by other devices
to connect as A2DP/AVRCP partner are rejected
until the current device is disconnected.
The same device may connect as both A2DP/
AVRCP and HFP partner. This normally happens
to mobile phone with wireless music streaming
capability. However, using the same device might
cause the A2DP/AVRCP to be disconnected when
there is an incoming call or making a call.
Please refer chapter "Audio Streaming
Operations" on page 27 for music streaming
functionality.
Cancelling pairing mode
1. During pairing mode, press the [
to cancel Pairing mode.
2. The display returns to previous mode.
Deleting paired devices
1. Select "DEL DEV" from Telephone Menu mode.
2. Press the [ENT] button. If there is device paired,
"XXXXXXXX" will be displayed
4. Press [ ]/[ ] button to select a device to be
deleted and press the [ENT] button.
5. Turn the [ /VOL/MODE] knob to select "YES"
and press [ENT] button for the confirmation.
6. During "DEL ALL", press the [ENT] button will
delete all devices. "DELETED" will be displayed.
Note:
Upon finish deleting, display will switch to next
device name.

Connecting Bluetooth

The unit will automatically connect to the paired
device after pairing. However, some phones will
not allow automatic connection to the device after
pairing; please use the phone to manually connect
to the unit. Connection can be established at
any Source mode. If connection is unsuccessful,
automatic connection will stop.
1. Select "CONNECT" from Telephone Menu mode.
2. Press [ENT] button.
3. Unit will try to establish a connection with the
last connected phone.
Notes:
The " " indicator will light on and "CONNECT"
will be displayed upon successful connection.
] button once
The unit will also automatically connect to the last
connected phone when car ignition is turned on.
Make sure your phone's Bluetooth
turned on, within acceptable range and no other
Bluetooth devices such as headset is connected
®
during automatic connection.
Connection activated through unit is only HFP
(Handsfree).
Audio streaming connection will need to be
initiated by the Bluetooth
Some phones will connect audio streaming as
well when HFP is connected.
Any connection attempt with a new device will
require disconnecting previously connected
device first. Otherwise, connection will not be
device
®
function is
®
audio device itself.
®
25