Troubleshooting (Helps You To Quickly Solve Any Problems You May Encounter While Using The Machine) - EMAK TN 4500 Manual De Uso Y Mantenimiento

I
WARNING: always stop the machine before carrying out any of the corrective checks recommended
in the table below, except when they require the unit to be in operation.
When all the possible causes have been checked and the problem is not resolved, consult an Authorised Service
Centre. If a problem occurs that is not listed in this table, consult an Authorised Service Centre.
GB
PROBLEM
1. Engine does not start.
F
D
2. Starting is difficult or the engine
E
runs erratically.
NL
3. Erratic forward movement, poor
drive when going uphill or
machine has a tendency to rear
P up.
4. The drive does not work
H
5. The machine does not bend to
the left and / or right
6. In the parking position, with the
engine running, the machine
SK
tends to move forward
7. In the parking position, on
slopes and with the engine off,
CZ
the machine moves
8. Machine noisy at the start
RUS
9. The crawlers touch the box when
UK
the machine is running
10. The gears do not engage
PL
11. Unlocking of the half-shafts is
accompanied by a metallic
sound
FIN
12. First gear and reverse gear do
not remain engaged
BIH
13. The load box does not lift or it
SRB
lifts in with stop-start motion
HR
(models 550D-1750D-50D)
WARNING: Do not attempt to carry out repairs without the necessary repairs and technical
expertise. Poorly executed repairs will automatically invalidate the warranty and relieve the
manufacturer of all liability.
40
13. TROUBLESHOOTING
POSSIBLE CAUSES
a) no fuel supply
b) faulty ignition
c) carburetor throttle does not
close completely
Carburetion fault
a) problems with the transmission
belt tension
b) transmission problems
c) incorrect belt tension
d) worn or broken belt
The cable release lever drive shafts
is not properly adjusted
Incorrect belt tension
Brake shoes worn or incorrectly
adjusted
Incorrect clutch lever cable tension Contact an Authorized Service
Incorrect crawlers tension
Worn gearbox forks
Half-shafts release cable incorrect
tension
Incorrectly adjusted gear lever
a) low hydraulic oil level
b) hydraulic oil line incorrectly
tightened
SOLUTION
a) - check fuel level
- open fuel stop-cock
b) - check that spark plug cap is
firmly fitted
- check that the electrodes are
clean and correctly spaced
c) contact an Authorized
Service Center
- clean or replace air filter
- empty fuel tank and refill
with new fuel
- check fuel filter and replace
if necessary
Contact an Authorised Service
Centre
Contact an Authorized Service
Center
Contact an Authorized Service
Center
Contact an Authorized Service
Center
Contact an Authorized Service
Center
Center
Contact an Authorized Service
Center
Contact an Authorized Service
Center
Contact an Authorized Service
Center
Contact an Authorized Service
Center
a) check the hydraulic oil level
and replenish if necessary
b) contact an Authorized Service
Centre