Using The Adhesive Patch; Physical Characteristics Of The Vercise Gevia Stimulator - Boston Scientific Vercise Gevia 16 Instrucciones De Uso

Vercise Gevia™ 16 Contact IPG DFU

Using the Adhesive Patch

Note: The Adhesive Patches are made of non-reactive and natual Latex-free material
suitable for most sensitive skin types.
a. Apply the Adhesive Patch to the backside of the Charger by peeling the clear liner from the
patch and applying the white side with the blue stripe to the rear of the Charger.
b. Remove the skin side beige liner from the adhesive (only good for one fixation).
c. For best charging results, make sure the Charger is centered over the Stimulator. If the
Charger is not centered, charging time may increase. When the Charger is aligned with the
Stimulator, the beeping will stop.
WARNING: Do not put the Charger directly on the skin (e.g., without an Adhesive Patch).
This may result in uncomfortable heating of the skin or a burn.
4. When the Charger emits a series of double beeps, the Stimulator is fully charged. Turn off the
Charger and remove the collar or adhesive patch, and return the Charger to the Base Station.
Note: Do not confuse the end of charge signal (a series of double beeps) with the
repeated beeps that indicate that the Charger is searching for the Stimulator.
Note: The Remote Control will not be able to communicate with the Stimulator when
charging.

Physical Characteristics of the Vercise Gevia Stimulator

The physical characteristics of the Stimulator are outlined in Table 1. The Stimulator contains a
radiopaque identification tag. The identification tag is visible using standard x-ray procedures.
Table 1: Stimulator Physical Properties
Feature
Case
Header
Strain Relief
Dimensions
Volume
Vercise Gevia™ 16 Contact IPG DFU
91168761-02 Rev A Page 12 of 397
Description
Titanium
Epoxy
Silicone
51.3 mm x 46.0 mm x 10.8 mm
19.8 cm (including header)
3