Dräger WorkMaster Industry Instrucciones De Uso página 29

Marking
Model Identification
See identification tag inside the
chemical protective suit, level with
the left shoulder blade.
Example:
NOTICE
The identification tag inside the chemical protective suit may
vary from this illustration.
The respectively valid approval can be found on the marking
in the identification fields.
Explanation of the Model Identification
NOTICE
The following explanation applies for the current status of the
model identification. It can contain information that is not
available on each identification tag.
Boot Size and Material:
NB/NE (Nitril) available sizes: see "Order List" on
page 37
PVC available sizes: see "Order List"
Glove Size and Material
FKM/IIR Viton/Butyl
available sizes: see "Order List"
FKM Viton
available sizes: see "Order List"
IIR Butyl
available sizes: see "Order List"
Ventilation Units
AL integral ventilation valve Aerotec AL
BA integral ventilation valve Aerotec BA
RV integral control valve
RV PT integral control valve pass thru
B integral ventilation tabs
ASV automatic switch-over valve
Mask
RA integral full face mask with round thread
connection
P integral full face mask with positive
pressure plug connection
PE integral full face mask with positive
pressure standard connection
ESA integral full face mask with positive
pressure standard plug-in connection
G facial cuff
Zip Fastener Type:
RV I zip fastener with covered mechanism
RV A zip fastener with exposed mechanism
Fp zip fastener with flap
Testing Standard
1b ET suit according to EN 943-2:2002 1b-ET
1b suit according to EN 943-1:2002 1b
S integral socks
available sizes: see "Order List"
29