Explanation Of Symbols - Dräger WorkMaster Industry Instrucciones De Uso

Supplied Air Systems
— ABIL-L-1
Lung Demand Valves
— Lung demand valve with standard thread according
to EN 148-1 (N)
— Lung demand valve with angular thread M 45x3 according
to EN 148-3 (AE)
— Lung demand valve with plug connection (A)
— Lung demand valve with plug connection (ESA)
Ventilation Units
— RV PT 120L version B1 with Aerotec AL
— RV PT 120L version B2 with Aerotec BA
— RV PT 120L version B3 excl. ASV
1)
— RV PT 120L version B4
— Automatic Changeover Switch for CPS (ASV)
Before first use, the entrepreneur/user must ensure the follow-
ing (see European Directive 89/656/EEC):
— the fit must be perfect, e. g. to ensure an absolutely tight fit,
— the Personal Protective Equipment must be compatible
with other types of protection equipment worn at the same
time,
— the Personal Protective Equipment must be suitable for
existing workplace conditions,
— the Personal Protective Equipment must meet ergonomic
requirements.

Explanation of Symbols

Caution! Strictly follow the Instructions for Use.
Clothing providing protection against gaseous,
liquid, aerosol and solid chemicals.
Clothing providing protection against
infectious agents.
Clothing for protection against radioactive
contamination.
Clothing according to the Marine Equipment
Directive
1) Not approved according to the German Fire Protection Association
0801 : 2006-11
22
Preparation
For storage purposes, Dräger recommends using the flat
pouch in which the chemical protective suit was delivered.
Spread out the chemical protective suit evenly on the floor.
Visual inspection: The chemical protective suit, protective
boots and gloves may not have holes or tears.
Do not use damaged chemical protective suits. Before
using the equipment for the first time, carry out leak test to
detect possible damages due to transportation, after that
observe the maintenance intervals (see "Maintenance Inter-
vals" on page 31).
1)
Apply antimisting agent "klar-pilot" gel to the inside of the
1)
visor of the full face mask
from fogging.
Do not treat the visor with antimisting agent, this would
destroy the antifog coating.
Check the function of the ventilation valve and the auto-
matic switch-over valve
Handling the Closure System
To avoid damages to the closure system, both halves of the
zip fastener must be placed unstressed in parallel to each
other. Do not use force during opening and closing the zip
fastener.
Do not suddenly pull the zip fastener.
Otherwise the closure system could be damaged.
The closure system has been developed especially for
chemical protective suits. Due to the additional seals these
systems generally require more handling force than zip fasten-
ers used in normal clothes.
Insufficiently lubricated closure systems are difficult to oper-
ate. This could result in damage of the closure system.
Lubricate the closure system! Use the original DYNAT main-
tenance set
To avoid wrinkling the closure system, a second person must
take hold of the closure system with both hands and then pull
the trouser leg over the protective boots so that the closure
system shows no wrinkles.
The person wearing the protective suit should stand upright
while the closure system is opened and closed.
2) Follow the separate Instructions for Use of the product.
NOTICE
2)
to prevent the full face mask
CAUTION
2)
.
CAUTION
CAUTION
2)
.