Features And Controls; Oil Recommendations - Simplicity SZT275 Manual Del Operador

• Operator rises off seat with parking brake not engaged.
TEST 4 - Check mower blade stopping time
The mower blades and mower drive belt should come to a
complete stop within five seconds after the electric PTO switch
is turned off. If mower drive belt does not stop within five
seconds, see your dealer.
Once the engine has stopped, the PTO switch must be turned
off, the parking brake must be engaged, and the ground speed
levers must be locked in their START/PARK positions in order
to start the engine.

Features and Controls

Compare the features and controls in Figure 2 with the table
following.
Ref. Description / Function
A Deck Lift Pedal, Cutting Height
Adjustment Pin and Deck Lift Lock
Lever - adjusts cutting height
B Parking Brake (models with
manual parking brake only)
C Engine Speed Control - controls
engine speed
D Ignition Switch - starts engine
E PTO Switch - engages and
disengages mower blade clutch
F Hour Meter
G Transmission Release Levers -
release transmissions so unit can
roll freely
H Fuel Tank Cap
I Operator's Seat Adjust
Icon(s) Definition /
Operation
See Cutting Height
Adjustment
Engage - Move lever
forward and to the right
Disengage - Move lever to
the left and back
Choke on (closed) - Briggs
engines only
Engine speed fast
Engine speed slow
Engine off
Engine on (run)
Engine start
PTO engage - pull up on
switch
Indicates total hours of
engine operation
See Pushing the Unit by
Hand
Turn cap counterclockwise
to remove
See Seat Adjustments
Ref. Description / Function
J Left Ground Speed Lever -
controls speed and direction of left
drive wheel
K Right Ground Speed Lever -
controls speed and direction of
right drive wheel; also engages
parking brake *
Operation

Oil Recommendations

Oil Capacity: See the Specifications section.
We recommend the use of Briggs & Stratton Warranty Certified
oils for best performance. Other high-quality detergent oils are
acceptable if classified for service SF, SG, SH, SJ or higher.
Do not use special additives.
Outdoor temperatures determine the proper oil viscosity for the
engine. Use the chart to select the best viscosity for the outdoor
temperature range expected.
A SAE 30 - Below 40 °F (4 °C) the use of SAE 30 will result in hard
starting.
B 10W-30 - Above 80 °F (27 °C) the use of 10W-30 may cause increased
oil consumption. Check oil level more frequently.
C Synthetic 5W-30
D 5W-30
Icon(s) Definition /
Operation
Forward ground speed
increase - push lever
forward
Neutral - release lever
Engine start - move lever
out
Reverse ground speed
increase - pull lever back
Forward ground speed
increase - push lever
forward
Neutral - release lever
Engine start - move lever
out
Reverse ground speed
increase - pull lever back
* Parking brake (models
with automatic parking
brake only)
Engage - move lever out
Disengage - move lever in
11