Operation Using Machine-Mounted Tools - RIDGID 1224 Manual De Uso

1224 Threading Machine
minimum of three (3) feet of clearance around the
Threading Machine and workpiece. This "safety zone"
prevents others from accidentally contacting the ma-
chine or workpiece and either causing the equipment
to tip or becoming entangled in the rotating parts.
5. If necessary, fill the reservoir with RIDGID Thread
Cutting Oil.
6. Make sure FOR/OFF/REV switch is in the OFF position.
7. Position the foot switch so that the operator can safely
control the machine, tools and workpiece. It should
allow the operator to do the following:
• Stand facing the directional switch.
• Use the foot switch with his left foot.
• Have convenient access to the directional switch,
tools and chucks without reaching across the ma-
chine.
Machine is designed for one person operation.
8. Plug the Threading Machine into the electrical outlet
making sure to position the power cord along the clear
path selected earlier. If the power cord does not reach
the outlet, use an extension cord in good condition.
WARNING
To avoid electrical shock and electrical fires, never use
an extension cord that is damaged or does not meet the
following requirements:
• The cord has a three-prong plug similar to shown
in Electrical Safety section.
• The cord is rated as "W" or "W-A" if being used
outdoors.
• The cord has sufficient wire thickness (14 AWG
below 25'/12 AWG 25' - 50'). If the wire thickness is
too small, the cord may overheat, melting the cord's
insulation or causing nearby objects to ignite.
WARNING To reduce risk of electrical shock, keep all
electrical connections dry and off the ground. Do not
touch plug with wet hands.
9. Check the Threading Machine to insure it is operating
properly.
• Flip the directional switch to FOR (Forward). Press
and release the foot switch. Check that the
Threading Machine rotates in a counterclockwise di-
rection as you are facing the front chuck. Have the
Threading Machine serviced if it rotates in the
wrong direction or if the foot switch does not control
its stopping or starting.
8
• Place die head in down position. Step on foot switch
and oil should flow from die head. Release foot
switch and return die head to up position.
• Depress and hold the foot switch. Inspect the moving
parts for misalignment, binding, odd noises or any
other unusual conditions that may affect the safe and
normal operation of the machine. If such conditions
are present, have the power drive serviced.
• Flip the directional switch to REV (Reverse). Press
and release the foot switch. Check that that
Threading Machine rotates in a clockwise direc-
tion as you are facing the chuck.
• Release the foot switch and flip the directional
switch to OFF.
Operation Using
Machine-Mounted Tools
Do not wear gloves or loose clothing when operating
Threading Machine. Keep sleeves and jackets but-
toned. Do not reach across the machine or pipe.
Do not use this Threading Machine if the foot switch
is broken or missing. Always wear eye protection
to protect eyes from dirt and other foreign objects.
Keep hands away from rotating pipe and fittings.
Stop the machine before wiping pipe threads or
screwing on fittings. Allow the machine to come to
a complete stop before touching the pipe or ma-
chine chucks.
Do not use this machine to "make-on" or "break
off" fittings. This practice is not an intended use of
this Threading Machine.
Installing Pipe In Threading Machine:
1. Check to insure the cutter, reamer and die head are
swung to UP position.
2. Mark the pipe at the desired length if it is being cut to
length.
3. Insert the pipe into the Threading Machine so that the
end to be worked or the cutting mark is located about
12 inches to the front of the speed chuck jaws.
4. Insert workpieces less than 2 feet long from the front
of the machine. Insert longer pipes through either
end so that the longer section extends out beyond the
rear of the Threading Machine.
Ridge Tool Company
WARNING