Jacuzzi Maxi Manual De Instalación página 27

display
pump
spotlight
Display and adjust temperature
Function parameters
I
PREPARING FOR USE
CAUTION
The preliminary checks and any system ad-
justments must be performed by qualified au-
thorised personnel, under their own respon-
sibility.
Instructions are provided in the second part
of this manual.
The user must appoint a qualified person able to manage
and run the system, in particular as regards the following op-
erations:
Filling the MaxiJacuzzi
The optimum level is obtained when the water reaches the
level mark on the skimmer (
Verification of water quality, chemical control of pH
and water sanitation.
These checks must be performed frequently to guarantee
long-term water quality, especially if the MaxiJacuzzi
used by several persons.
Make sure that ALL the operations described in the
section "Operating instructions for the system user Gen-
eral Warnings Initial Start- up" have been carried out.
TURN ON the system's main switch.
® with water.
i
2, detail A).
CAUTION
Do not power the system if the MaxiJacuzzi
not filled with water up to the normal filling lev-
el, as this may damage the pump.
Failure to observe this warning will immediate-
ly invalidate the warranty.
I
LIMITATION OF ELECTRICAL CONSUMPTION
If there is not enough electrical energy and you decide to ac-
tivate the consumption limiter, the system software must be
configured for proper operation of the spa:
Press and hold the "Light"
til the message"cFn" appears.
If necessary, use the "Up"
scroll the menu until you see "cFn". Press the "Light"
gain to confirm the option.
Now insert the password 123 as follows:
® is
- use the "Up"
number.
- confirm the selection by pressing the "Light"
Perform the same steps to insert the other two numbers.
Once you have inserted the password, the display will show
the message I1x (parameter for temperature unit of measure.
Press the "Light"
"x" may be 1 or 0; the default is 1).
27
Pump operation LED
Spotlight operation LED
Filtering cycle LED
Heater operation LED
Temperature adjustment LED
key for about 12 seconds, un-
and/or "Down"
and/or "Down" keys to insert the first
key again to go to parameter I2x (where
i
7
® is
keys to
key a-
key.