Jacuzzi Maxi Manual De Instalación página 28

i
8
Use the "Up" and/or "Down"
from 1 to 0 and then confirm the selection with the "Light" * key.
The display will show the message I3 0. Press the "Light"
key again to exit the procedure and memorize the new values.
Make sure you do not modify parameter I3 0. The display will
go off for a moment, and then it will come on again.
- If no key is pressed for 20 seconds, you will exit the proce-
dure and any changes made will not be saved.
NOTES
- When I2 is 0, electrical consumption of the spa is limited to
16A. Under this condition you can simultaneously turn on a
hydromassage pump at low speed and the heater. When you
turn on the pump at high speed, the heater is turned off.
When I2 is 1, maximum electrical consumption is selected. In
these conditions it is possible to activate both the hydromas-
sage pump at high speed and the heater.
- It is not advisable to activate the consumption limiter if the s-
pa is installed where temperatures often drop below 0 °C because
this limits the anti-freeze protection (see related chapter).
I
CONTROL PANEL AND FUNCTIONS
Below you will find a description of the functions of your
MaxiJacuzzi ® and the methods for activating them via the
keys of the control panel (
I
"Pump"
key
Press the button once to start the pump at low speed; the
respective LED will flash. Press it again to go to high speed
(the LED will be on and steady). Press the button a third
time to shut down the pump (the LED turns off).
Andros - Oxia
Andros - Oxia
keys to change "x"
i
7).
Kios Friendly
A
Kios Friendly
B
NOTES
- If the pump is activated via the button (at low and high
speeds), it will automatically shut off after 20 minutes un-
less turned off earlier by the user.
Note that when the pump starts automatically at low speed
(such as during a filtering cycle or when heating the wa-
ter), it can not be shut off from the display. It can however
be set to high speed by pressing the appropriate button.
I
Whirlpool nozzles and their layout
The jets integrated in the massage seats allow you to di-
rect the water at specific points of your back for in-depth
massage that relaxes the muscles and reduces stress.
According to your position, the whirlpool jets massage the
lumbar area, shoulders, arms, hips, thighs or calves.
The vertical jets are designed for relaxing foot and ankle
massage, improving the circulation. Since all of the jets
can be direction-adjusted, you can aim the jets at tense or
stiff muscles. The warmth and the stimulating flow of the wa-
ter will increase blood flow.
In some jets the water flow can be adjusted via the intake
outer ring nut.
The intensity of the whirlpool is determined by the amount of
air introduced into the water, regulated by means of control
knobs on the edge of the MaxiJacuzzi
To obtain the maximum amount of air, turn each knob clock-
wise; turn counter-clockwise to reduce the amount of air.
28
i
® ( 8, detail A).