Jacuzzi Maxi Manual De Instalación página 33

Remove the spa from the packaging and remove the front
i
panels ( 5 ). First unscrew the screws at the base (detail
1) and then slide out the panels from the threaded pins (de-
tail 2). The corner panels must not be removed.
If the MaxiJacuzzi is supplied with a wooden outer cover, for its dis-
assembly and re-assembly (after the final positioning of the tub),
i
refer to .
6
i
( 1) For all transport operations use only the pallet on
which the MaxiJacuzzi ® is placed. During installation support
it by using only straps of adequate capacity, that can be in-
serted into the runners and brackets at the bottom of the s-
pa. After final installation, these brackets can be removed
and kept for any future handling.
If it is impossible to use transport belts, the methacrylate pan-
els screw-fitted at the four corners can be removed so that the
corner props can be used as supports for moving the spa.
NOTE: this type of movement must be performed with
extreme care and the customer or its representative must
assume full responsibility for it.
Jacuzzi Europe S.p.A. accepts no liability for damages
caused by said operation or any other inappropriate han-
dling procedures.
CAUTION
NEVER lift the MaxiJacuzzi
pipes.
Carefully inspect the MaxiJacuzzi
installation, checking the correct position of the couplings,
pipes and clamps (check that they are not loose).
I
INSTALLATION
Your MaxiJacuzzi ® has been designed so that the only re-
quirements for operation are connection to the electricity
mains, earth, drain outlet and water mains, all previously pre-
pared (see the attached "Pre-Installation Instructions").
To create a suitable support base, the gross weight must be
considered (when water and persons are added) and the re-
sulting load on the floor, depending on the selected model
See the attached pre-installation sheet.
i
MaxiJacuzzi
( 2) The
roughly on the centreline of the base. Therefore, a drain must be
located nearby (see the attached "Pre-Installation Instructions").
For periodic emptying, a hose can be connected to the drain.
To do so, first remove the plug on the base and then screw on
the fitting with its gasket
® by its edge or by its
® before proceeding with
®
is equipped with a drain valve located
1
3
4
Notes
To open the valve, turn the ring nut counter-clockwise and pull.
If you decide to attach the
visable to connect upstream from the valve (for greater flow ca-
pacity) and to install a shutter valve near the drain in an ac-
i
cessible area ( 2, part. D).
CAUTION
If for periodic filling the
nected to the city mains that provide drinking
water, contact local authorities first in order to
ascertain compliance with anti-pollution laws in
each nation. For EC countries, refer to standard
EN 1717.
For connection to the electrical mains, refer to the in-
structions in the pre-installation sheet and the chapter "Elec-
trical connections". Please remember that the mains circuit
breaker must be located in an area that is safe and accessi-
ble to the user.
Electrical connections
Make the connection on the terminal board as shown in
4.
For the characteristics of the cables, switches etc., consult the
pre-installation sheet provided, in particular the chapter on
ELECTRICAL SAFETY.
To ensure the degree of protection against water as required
by standards, a cable clamp has been installed to make con-
nection the electrical system easier.
The installer must in any case connect the phase wire to the
correct terminal and the neutral wire to terminal N (in the order
indicated). He must also connect the earth wire to the terminal
33
2
5
MaxiJacuzzi ®
to the drain, it is ad-
MaxiJacuzzi ® is con-
i