Publicidad
3.4 COLOCACIÓN ETIQUETA EN VISOR.
PLACEMENT OF THE NAME TAG IN THE VIEWER.
1
Extract the audio group from the street panel.
3
Separate the translucent glass part, insert name tag and replace the translucent glass part.
Extract translucent glass part.
4
Attach the viewer to the audio group. Insert the audio group in the street panel.
3.5 RECOMENDACIONES DE INSTALACIÓN DE LAS PLACAS CALLE.
RECOMMENDATIONS FOR THE INSTALLATION OF STREET PANELS.
Extract the audio group by
levering with a screwdriver.
Insert name tag.
The street panel is sufficiently protected against
a t m o s p h e r i c c o n d i t i o n s . H o w e v e r, i t i s
recommendable to install it in a place where agents
such as rain, humidity, etc. cannot affect it.
When the street panel is exposed to the elements
it is recommendable to install it with a visor frame.
In the case of surfaces that are not smooth, where
the street panel or visor frame are not perfectly sealed
with the joints that are incorporated, then some sort
of sealer should be applied throughout the entire
upper part of the street panel or visor frame to thus
avoid water from penetrating and damaging the
equipment.
2
Press on the parts indicated to remove the viewer.
Parts to be pressed.
Replace translucent glass part.
When choosing the location to install a video
door entry system it is important to find a
location where the source of light (sun, street
lamps, etc.) does not directly affect the
camera, to thus avoid the effect of the back
light on the image.
If the image is not clear and sharp due to
a lack of light for camera, then auxiliary
lighting should be placed as is duly indicated
in the figure. This auxiliary lighting can be
installed in such a way that it only lights up
the scene when a monitor is working.
Publicidad
