Publicidad
MICROSWITCH 1 OPTION 1. CONFIGURATION OF THE ACCESS CODE:
MICROSWITCH 1 OPTION 2. ACTIVATE/DEACTIVATE CAMERA:
This option is to configure street panel for it to activate or not the video (camera) when performing surveillance via a monitor. There may
be a maximum of 4 deactivated secondary or external street panels with consecutive numbers. In surveillance state, audio communication
can be established from the monitor and the door corresponding to the street panel can be opened.
NORMAL FUNCTIONING
NORMAL FUNCTIONING
ACTIVATE/DEACTIVATE CAMERA.
CONFIGURATION OF THE ACCESS CODE.
IMPORTANT: THE ACCESS CODE CAN ONLY BE CONFIGURED
IN STREET PANELS WITH A TELEPHONE NUMBER PAD.
Process to be followed:
a) Set microswitch 1 to the ON position and the red LED of the
telephone number pad will light up.
b) Press key "
" and then the code digits (between 1 and 6
digits).
c) Once the code has been entered, press "
opener will be activated and the green LED of the number pad
will light up for a few seconds, indicating the new code has
been saved.
d) Finally, reinstate microswitch 1 to the normal functioning position.
The red LED will switch off.
Process to be followed:
a) Set microswitch 1 in the group of four microswitches (CONFIG
group in the figure) to the ON position. The red indicator will
light up if the street panel has a telephone number pad. If the
street panel has a camera, this will be activated.
b) To deactivate the camera, change the position of microswitch
1 in the group of six microswitches (No. group in the figure) to
then go back to the original position.
c) Reinstate microswitch 1 in the group of four microswitches
(CONFIG group in the figure) to the OFF position. The new
camera status will be saved and the red indicator of the
telephone number pad and the camera will switch off.
The process followed to activate a previously deactivated camera
is exactly the same.
" again. The door
Publicidad
