Mettler Toledo IND560x Manual De Instalación página 49

4. The opening (or cut-out) in the control panel or industrial enclosure should be sized per the
5. Place the IND560x terminal through the cut-out/opening in the control panel or enclosure door.
6. If the optional panel stiffener bracket is to be used (#64005775), install it over the rear of the
7. Secure the terminal to the panel by inserting the clamping brackets into the channels on the
64061929 | 11 | 07/2017
Gasket
installed
panel cutout dimensions shown in Figure 3-7. Dimensions are provided in inches and
[millimeters].
It may be necessary to remove all terminal strip connectors to fit the IND560x through the
cutout/opening.
enclosure at this time.
side of the IND560x enclosure and installing the four Allen-head screws as shown in Figure
3-8. All four set screws should be tightened to 0.55 Nm (5 in-lbs).
NOTE: Before tightening, make sure the IND560x terminal is installed level in the opening.
Figure 3-6: Front Panel Gasket Installed
Figure 3-7: Panel Cutout Dimensions
METTLER TOLEDO IND560x Installation Manual 3-5