Mettler Toledo IND560x Manual De Instalación página 58

3.3.3.1. Power Connection
3.3.3.1.1. External Power Supply
One PSUx power supply, APS768x power supply or an external NiMH battery (P/N 64060625) is
required to operate the IND560x terminal. The PSUx and APS768x power supplies include a 5m
(16 ft.) long integral cable that must be terminated at the IND560x terminal. This cable also
includes the required gland for the IND560x.
If the 5m (16 ft.) integral cable is not long enough for the application, it can be replaced with a
longer cable. This procedure is described in the APS768x or PSUx power supply installation
manual.
Before beginning to terminate the cable, install the gland on the end of the APS768x or PSUx cable
into the empty hole identified in Figure 3-16.
The wires from the APS768x or PSUx terminate at the nine terminals of J4 and J5 ports on the
main board of the IND560x (also identified as the "P" connection blocks). as shown in Figure
3-20.
3-14 METTLER TOLEDO IND560x Installation Manual
Analog scale
connector
Power supply
connectors
Figure 3-19: Panel-Mount Enclosure Connector Locations
IDNet or SICSpro
connector
COM1
connector
SW2
64061929 | 11 | 07/2017