Mettler Toledo IND560x Manual De Instalación página 55

terminal enclosure. Each cable that enters the enclosure has been assigned a specific location. The
location of each of the glands and plugs is shown in Figure 3-16.
To ensure a watertight and dust tight seal:
1. Pass the appropriately sized cable through the correct gland before connecting the wires.
1. When making cable terminations inside the harsh enclosure, ensure that the cable length from
2. Cables that include shields should have the shield terminated at the gland as shown in Figure
64061929 | 11 | 07/2017
Power
Supply or
Battery Pack
Optional
COM5 CL or
FO Interface
Optional
COM4 CL or
FO Interface
Figure 3-16: Cable Gland and Plug Assignments
Depending upon the gland size, a specific size diameter cable must be used. The required
cable sizes are shown in Table 3-2.
Gland
Analog load cell, IDNet and
SICSpro
COM1
Discrete input
Discrete output
CL interface
FO Interface
External Battery Pack
NOTE: When installing the fiber optic interface option, a special split grommet is provided
to seal around the fiber optic cables.
IMPORTANT: Use only ATEX certified glands and blanks with the IND560x harsh terminal
the terminal strip/connector to the terminal housing is sufficient so that no strain is placed on
the connector assembly when the housing is in the fully open position.
3-17. Spread the shield wires out and make sure enough shield wire is present to make good
contact with the metal part of the gland.
NOTE: The shield of the cable from the IND560x to the ACM500 must not be terminated at
the ACM500 end. The shield must be left open at the ACM500 end of the cable.
Table 3-2: Cable Diameters for Glands
6–10 mm (0.24–0.39 in.)
6–10 mm (0.24–0.39 in.)
6–10 mm (0.24–0.39 in.)
6–10 mm (0.24–0.39 in.)
6–10 mm (0.24–0.39 in.)
2.2 mm (0.09 in) Special grommet included with interface
4-8 mm (0.16–0.3 in)
METTLER TOLEDO IND560x Installation Manual
Scale interface
COM1
I/O
Cable Diameter
3-11