After Installation; Care & Cleaning; Technical Information - LUCCI Air AIRFUSION A Manual De Operación, Instalación Y Mantenimiento

Airfusion Type A Installation Instructions
Solution:

Switch off the main power to ceiling fan.

Press and hold the "
receiver of the ceiling fan.

Turn ON and change the speed of the ceiling fan by the transmitter to check the operation and successful
paring.
WOBBLE:
Note: Ceiling fans tend to move during operation due to the fact that they are mounted on a rubber grommet. If the
fan was mounted rigidly to the ceiling it would cause excessive vibration. Movement of a few centimeters is quite
acceptable and does not suggest any problem.
TO REDUCE THE FAN WOBBLE: Please check that all screws which fix the mounting bracket and down rod are
secure.
BALANCING KIT: A balancing kit is provided to balance the ceiling fan on initial installation. Please refer to the
instruction on how to use the balancing kit. The balancing kit can be used to assist re-balancing should the ceiling fan
become un-balanced again. Store your balancing kit away after installation for future use if required.
NOISE:
When it is quiet (especially at night) you may hear occasional small noises. Slight power fluctuations and frequency
signals superimposed in the electricity for off-peak hot water control, may cause a change in fan motor noise.
This is normal. Please allow a 24-hour "settling-in" period, most noises associated with a new fan disappear during
this time.
The manufacturer's warranty covers actual faults that may develop and NOT minor complaints such as hearing the
motor run – all electric motors are audible to some extent.

Periodic cleaning of your ceiling fan is the only maintenance required. Use a soft brush or lint free cloth to avoid
scratching the paint finish. Please turn off electricity power when you do so.

Do not use water when cleaning your ceiling fan. It could damage the motor or the blades and create the possibility
of an electrical shock.

The motor has a permanently lubricated ball bearing. There is no need to oil.
NOTE: Always turn off the power at the mains switch before attempting to clean your fan.
AIRFUSION
SERIES TYPE A
DC FAN models
60" blade fan only
9 | P a g e
" button on transmitter for 3 seconds within 60 seconds of switching the power to the

AFTER INSTALLATION

CARE & CLEANING

TECHNICAL INFORMATION

Rated Voltage
220-240VAC
Rated power
Battery for remote
(motor)
35W 2 x 1.5Vdc AAA