Tabla de contenido
Publicidad
ENGLISH
3.7 FUNCTIONING MODE
When the monitor is switched on, a test of approx. 2 seconds is
run. At the end of the test, the version of the software (e.g.: "U 2.0")
is displayed for about 1 second.
Successively, the hours of operation are displayed for approx. 3
seconds and during this period the hours can be reset by pressing
+
-
either the "
" or "
" key.
After this operation the partial tilled area is shown on the display
(section B switches on).
During operation periodically check the dot on the display (Fig.
10): if it flashes pulses are sensed correctly.
- If the dot does not flash, check that the sensor is correctly
mounted.
- Check that residue is not impeding normal impulse reading.
3.7.1 SURFACE READINGS
The HCS hectare-counter permits simple reading of partially or
totally covered surfaces, operating in the following way:
- PARTIAL surface: this value is always shown with two decimals
in operation mode (e.g. 48.32, Fig. 11).
- TOTAL surface: press the "
counter shows the total tilled area with one decimal (e.g. 62.8,
Fig. 12).
3.7.2 RESETTING THE SURFACES
- PARTIAL surface: press the "
least 3 seconds until it is reset to 0.00. This operation enables
resetting of the partial surface value.
- TOTAL surface: press the "
-
press the "
" key and hold it pressed for at least 3 seconds until
it is reset to 0.0. This operation enables resetting of both the
partial and total surface values.
18
WARNING
-
" key for one second; the hectare
+
" key and hold it pressed for at
-
" key to view the total area. Then,
USE AND MAINTENANCE
fig. 10
fig. 11
fig. 12
cod. G19502721
Publicidad
Tabla de contenido
