If It Fails To Work - Tronic KH 3106 Instrucciones Para El Manejo Y La Seguridad

RZ_KH3106_Energiestation.qxd4
a) Connecting the device
Caution! Before connecting your
device to the energy station, you
must first ensure that "Positive"
and "Negative" are not switched.
Otherwise your device could be damaged.
With the supplied cable the device
connector is connected so that
Positive is on the inside and
Negative on the outside, as
shown. You can
- use this cable if the jack on your
device is marked thus:
- not use this cable if the jack on
your device is marked thus:
On devices with permanently con-
nected cable with motor vehicle con-
nector, "Positive" and "Negative" have
the correct polarity.
Insert the device connector of the
supplied cable in the jack on your
device.
Insert the motor vehicle connector
...
... in the motor vehicle socket on
the energy station.
Once you have connected your device
to the energy station ...
you can now set the main switch
to "ON" – your device will now be
supplied with power
A green LED "Full" will be illumi-
nated as soon as the main switch is
switched on and sufficient energy is
available.
A red LED "Empty" will be illumi-
nated as soon as the main switch is
switched on – but the battery is
almost empty.
07.11.2003 9:27 Uhr
Caution!.You will first have to
recharge the battery if the red LED
"Empty" is illuminated. Otherwise
the battery will be depleted, usually
resulting in a considerable loss of
charging capacity.
b) Removing the device
If you wish to terminate the power sup-
ply for your device from the energy sta-
tion, you should first ...
• switch off the device ...
• and also set the main switch on
the energy station to "OFF" (centre
position).
In this way you will prevent that current
is still flowing while the plug is being
pulled. Sensitive devices may malfunc-
tion as a consequence.
• You can now pull the connectors
from both the device and the ener-
gy station.

6. If it fails to work...?

If none of the two LEDs light up after
switching on, one of the fuses on the
energy station might have blown.
Changing the fuses is described in
more detail in Chapter 8.
Should an LED light up on the energy
station after switching on but your
device fail to work, you should imme-
diately switch off the energy station.
In this case, initially check whether the
cable is correctly connected – and
"Positive" and "Negative" have not
been switched. If required, also check
the fuse in your device as described in
its instructions.
51
Seite 51