Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Prestaciones
Welcome announcements
It is possible to define up to 20 (Aastra 415/430) or 50 (Aastra 470) welcome an-
nouncements. A welcome announcement comprises one or more (up to 20) se-
quences. In each sequence the parameters of the following table are to be configu-
red in AMS under
CM_5.4_Welcome
Tab. 313 Configuration per sequence of a welcome announcement
Parameter
Parameter value
File number
<10...29>
Pause signal
<Ring back tone
Internal audio source
Pause duration
<0...30> seconds
Next sequence
<1...20>
These configuration possibilities can be used to define complex welcome announ-
cements. An example of a welcome announcement with 3 sequences is given be-
low. The welcome announcement ends after sequence 3, and music is played until
the time configured under
elapsed. The connection is then cleared down.
Tab. 314 Example of a welcome announcement
Sequence
File number
1
10
2
11
3
12
It is also possible to define endless loops that consist of one or more sequences.
Example: If the figure 2 is entered as the next sequence at sequence 3, sequences 2
and 3 are repeated until the connection is cleared down.
Other settings in
CM_5.4_Announcement
Each welcome announcement can be individually activated or deactivated using
the
Status
parameter. The Delay parameter can also be configured within a range of
0 to 100 seconds for each welcome announcement (default value: 10 s). This value
defines the amount of time before the unanswered call is answered by the announ-
cement service. The
ter that applies throughout the system. It determines whether or not internal calls
504
announcements:
/
External audio source
/
Do not
disturb>
Internal ringing duration
Pause signal
Ring-back tone
External audio source
External audio source
Announcement service for internal users
Remarks
The file number is also included in the name of
the wave file.
/
This determines what is to be played in the pauses
between the sequences.
The default value is 15 seconds. If the pause dura-
tion is 0, the sequence skips directly to the next.
If the entry is the same sequence, it is repeated
endlessly. If the entry is blank or if it points to a
non-existent sequence, the welcome announce-
ment ends.
in
CM_2.3.3_Time settings
Pause duration [s]
15
30
30
service:
parameter is a parame-
Funciones y prestaciones del sistema a partir de R2.1
has
Next sequence
2
3
syd-0370/1.2 – R2.1 – 07.2012
Publicidad
Tabla de contenido
