Introduction; Filters Supplied; Crema Perfetta" Filter For 1 Or 2 Cups (Fig.5); Traditional Filter For 2 Cups (Fig.7) - Gaggia Milano CLASSIC Instrucciones Para El Uso

Introduction

Before using your machine for the first time, please
read the safety manual provided separately very
carefully and store it for future reference.

Filters supplied

"Crema perfetta" filter for 1 or 2
cups (Fig.5)
This filter is already installed on the filter holder and
allows you to obtain an espresso with cream even
when using the machine for the first time.
Note. This filter must be used only together with
the frothing jet device. (Fig.1-16).
Traditional filter for 2 cups
(Fig.7)
Traditional filter for 1 cup /
single-dose pod (Fig.6)
These filters are like those used in professional
bar machines and require manual skills and
experience.
Note. These filters must not be used with the
frothing jet device. (Fig.1-16).
Our advice is to start with the "crema perfetta"
filter and then, once you have acquired manual
skills and experience, move on to traditional ones
to appreciate real barista use.

First installation

1. Remove the water tank cover (Fig.2) and fill it
with cold water up to the MAX level of the tank
(Fig.1-13).
2. Insert the plug into the outlet at the back of the
machine (Fig.9) and the other end of the power
cord into a wall socket with suitable voltage.
Press the on / off button (Fig.1-2), the power
indicator light turns on(Fig.1-4).
4219-460-45901 MANUAL GAG. CLASSIC-2019 RI9380 USA EN-FR-ES.indd 17

Loading the circuit

Warning! Do not activate the brew button
without loading the circuit first.
1. Place an empty cup under the brew unit (Fig.1-
8) without inserting the filter holder and press
the brew button (Fig.1-1).
You will hear the sound of the pump being
activated and after a few seconds the water
will start to come out of the brew unit (Fig.1-8).
2. After filling the cup (about 150cc), press the
brew button again (Fig.1-1).
Note. The pump self-primer might not work
temporarily because of an "air bubble".
If water does not come out of the brew unit (Fig.1-8),
continue as follows:
1. Place a cup under the steam wand (Fig.1-14).
2. Turn the knob (Fig.1-7) counter-clockwise to
open the steam/hot water dispensing knob.
3. Press the brew button (Fig.1-1) to activate the
pump.
4. After a few seconds, water will start coming
out of the steam wand.
Dispense about a cup of water.
5. Close the steam/hot water dispensing knob
(Fig.1-7).
6. Press the brew button again (Fig.1-1).
When using for the first time
or after a period of inactivity of
more than 2 weeks
Note. The water dispensed during this process
must be thrown away and is not suitable for food
use. If the container fills up during the cycle, stop
dispensing water and empty the container before
resuming the operation.
1. Rinse the water tank (Fig.2) (see section
"Cleaning the Water Tank") and fill it with fresh
drinking water.
2. Place a container under the steam wand (Fig.1-
14).
ENGLISH
17
03/12/2018 14:40:11