Flush Installation Of The Built-In Grill; Installation Of The Built-In Grill In The Worktop Cut-Out - bora PT 11-000 Instrucciones De Montaje Y De Uso

... Installation
Flush installation of built-in grill
The grill plate might expand during heating by as much as 1 mm at the
base and by up to 0.6 mm in width. The cut-out dimensions must therefore
be strictly adhered to, as the silicone adhesive is otherwise under too much
stress.
When installing one or more appliances to the left and/or right of the
Teppanyaki grill, always keep a gap of minimum 2 mm between all
appliances.
► Place the grill in the cut-out. Seal the
gaps around
temperature-resistant
adhesive. Remove excess silicone
adhesive with a putty knife.

Installation of the built-in grill in the worktop cut-out

When heating up, the grill plate expands by as much as 0.6 mm in width.
When installing one or more appliances to the left and/or right of the
Teppanyaki grill, always keep a gap of minimum 2 mm between all
appliances.
► Place the grill in the cut-out and secure it with the clamps. The clamps can be
turned towards the front, rear and side.
The BORA logo must be positioned in the rear right corner of the built-in grill.
10
the grill with
silicone
temperature-resistant
silicone adhesive
a