Elevated Leg Rest - Ki Mobility Liberty FT Manual De Instrucciones Y Garantía

V. SET UP & USE OF YOUR WHEELCHAIR
I. Elevated Leg Rest
1. Installation
a. Place swing away pivot saddle into the
receiver on front frame tube with the
footrest facing either inward or outward
from the frame. Similar to swing away
footrest pictured in Fig. 6 and 7.
b. Rotate the footrest so it aligns with the
frame until it locks into place in the
latch block.
2. Removal
a. To remove footrest, push release latch
toward the frame.
b. Rotate footrest outward and lift.
3. Extension Tube Adjustment
a. Remove mounting bolt that is threaded into the leg rest tube in the center of the pad
bracket (Fig. 10:C). In some circumstances this bolt may be inserted in the tube below
below the pivot bracket.
b. Slide footrest extension tube to the desired height.
c. Line up holes and replace the bolt through the leg rest tube and extension tube.
d. Follow same procedure on opposite side.
4. Angle Adjustment
a. To raise, lift up on the rear of the extension tube (Fig. 10:A). The rod will slide through the
ratchet in this direction. Stop at desired position.
b. To lower, firmly hold the leg from behind the extension tube (Fig. 10:A). Pull forward on the
lever (Fig. 10:B) and while holding the lever, lift the leg rest. Releasing the lever will cause
the leg rest to lock into position.
At the lowest point, footrests should be AT LEAST 2 ½ INCHES (6.35 cm) off the ground. If set
too low, they may "catch" on obstacles you would expect to find in normal use. This may cause
the chair to stop suddenly and tip forward.
WARNING: Avoid tripping or falling when you transfer. Ensure your feet do not get caught in the
space between the footrests and avoid putting weight on the footrests as the chair may tip
forward. A trip or fall could result in serious injury.
Fig. 10
A
19
B
C