Pro Elevated Leg Rest - Ki Mobility Liberty FT Manual De Instrucciones Y Garantía

V. SET UP & USE OF YOUR WHEELCHAIR
J. Pro Elevated Leg Rest
Installation
NOTE: The Pro ELR is mounted onto the chair the same way as a swing away hanger.
1. Place swing away pivot saddle into the receiver on front frame tube with the leg rest facing
either inward or outward from the frame.
2. Rotate the leg rest so that it aligns with the frame and locks into place in the latch block.
Adjusting Height of Calf Pad
1. Loosen nut (Fig. 11:A) using a 10mm wrench.
2. Slide calf pad arm up or down to desired location.
Retighten nut.
Adjusting Depth of Calf Pad
1. Remove screw (Fig. 11:B) and nut (Fig. 11:C) on calf
pad arm using a 5mm Allen wrench and a 13mm
wrench.
2. Pick the desired location based on the four predrilled
holes and reinstall screw and nut.
Adjusting Length of Footrest
1. Loosen set screw (Fig. 12:A) with a 4mm Allen
wrench.
2. Slide extension tube in or out to get to desired
length and secure by tightening set screw.
Use
1. To raise the Pro ELR, lift the leg rest tube (Fig.
13:A) to desired angle of elevation.
2. To lower the Pro ELR, press and hold the lever lock (Fig. 13:B) while pushing the leg rest tube
(Fig. 13:A) down.
NOTE: Remove the Pro ELR from the chair or remove
weight from the Pro ELR while lowering to avoid a
sudden drop when the lever lock is pushed.
NOTE: The calf pad can swing outward to clear the front
of the chair for transfers.
Removal
1. To remove leg rest, push or pull release latch.
2. Lift the leg rest straight upward to remove. You may
also swing the leg rest inward or outward before
lifting it off.
C
Fig. 12
Fig. 13
A
A
20
B
A
B
B
Fig. 11
A