Ingeteam
There are three different states:
Not performed
No autotest running and none has been performed during the time in which the inverter has
been switched on.
Reconnection
State awaiting reconnection for the next measurement after an Fmax, Fmin, Vmax or Vmin
check.
Completed
A full autotest has been carried out during the time in which the inverter has been switched on.
To start the autotest, press
observing whether the result is correct or incorrect. An autotest can be stopped when running by pressing
Stop Autotest.
The results screens for an autotest are then displayed if the test has been completed and a second case in which
the test has not been completed:
2016-01-11
2016-01-11
Autotest complete, correct result
10.24. Change display language
To change display language, access the Main menu > Settings > Languages.
10.25. Change date and time
To change the inverter's date and time access Main menu > Settings > Date & time.
10.26. Perform a partial delete of accumulated data
These inverters have total and partial meters for energy produced, connected time to grid and number of
connections to grid made. This data may be viewed in Main menu > Monitoring.
If you wish to delete the partial meters, access Main menu > Settings > Partial delete.
10.27. Block inverter screen
If you want to block the keypad/screen together to avoid undesired changes access Main menu > Advanced settings
> Block display and enable the block. To unblock it, press
Main menu > Advanced settings > Block display and disable block.
Pressing
you access the configured country / regulations information.
98
on Start Autotest. Access Result to consult the results of the different tests,
10:17
10:17
2016-01-11
2016-01-11
Autotest not complete, no result
in this order for three seconds. Re-access
ABE2011IQM01_C - Installation and Operation Manual
Display control
on
10:17
10:17