Inner Lining - SCHUBERTH C3 PRO Manual Del Usuario

C. THE HELMET
Tip:
The sun visor holders should remain in the lower position
while you install the visor.
Fitting the sun visor
1. Put the sun visor between the
snap connections and fi t it on to
the locating pegs on one side and
then on the other.
2. Position the sun visor between
helmet inner and outer shell and
lower it with the operating slide.
3. For safety, check that the sun visor
mechanism is functioning correctly

13. INNEr lINING

The replaceable inner lining of the C3 Pro is washable and ensures
both an excellent fi t and improved ventilation of the helmet.
The high-comfort cheek pads ensure that the helmet fi ts
comfortably around the cheeks, and the headband pad provides
an optimal fi t all around the head. The head pad sits comfortably
on the head without covering the ventilation channels (see
Section C. 14., Ventilation systems/Head ventilation).
The internal lining consists of skin-friendly materials throughout,
particularly in areas that come in contact with the head. These
are a soft, breathable COOLMAX
and moisture very well, a special noise-reducing Polygene
material with antibacterial properties and a sweat-absorbing
®
Interpower material.
76
®
material that transports heat
®
Removing the lining
1. Undo the snaps on the front straps
of the neck collar and pull the
neck collar out of the mounting by
pulling strongly inwards.
-> neuer Text (Close-Up noch von Tim)
2. Undo the two rear snaps of the
cheek pads as well as rear crown
liner retention fl ap button.
77