Control Panel Interface - Generac GT-530 El Manual Del Propietario

Operation
Section 3
3.1 — Control Panel Interface
WARNING
Only qualified service personnel may install, operate
and maintain this equipment. Failure to follow proper
installation requirements could result in death, serious
injury, and damage to equipment or property.
NOTE: The enclosed keys provided with this unit are
intended for service personnel use only.
Figure 3-1. Side Lock Location and Front Panel Removal
DANGER
Automatic start-up. Disconnect utility power and render
unit inoperable before working on unit. Failure to do so
will result in death or serious injury.
Before performing any maintenance on the generator, set
to OFF, remove 7.5 Amp fuse, T1 and T2 battery charge
fuses, and disconnect battery cables to prevent acciden-
tal start up. Disconnect the cable from the battery post
indicated by a NEGATIVE, NEG or (–) first, then remove
the POSITIVE, POS or (+) cable. When reconnecting the
cables, connect the POSITIVE cable first, the NEGATIVE
cable last.
Owner's Manual for 50 Hz Air-cooled Generators
The Control panel interface is located under the lid of the
enclosure. Before attempting to lift the lid of the enclo-
sure, verify that both left and right side locks are
unlocked. To remove the front cover, lift the cover straight
up to disengage the side hooks, then tilt and lift it away
from the unit.
When closing the unit, ensure that both left and right side
(000182)
locks are securely locked.
NOTE: All appropriate panels must be in place during
any operation of the generator. This includes operation
by a servicing technician, while conducting troubleshoot-
ing procedures.
(000191)
Figure 3-2. Generator Control Panel
Operation
000597
000425
9