Beta EVO 2T Serie Manual De Instrucciones página 58

Left shaft Left shaft Left shaft
Left shaft Left shaft
To replace the oil, proceed as follows:
1) Remove the front wheel
2) Remove the handlebar (see pag. 69)
3) Loosen the shaft lock screws A A A A A
4) Unscrew slider plug B B B B B
5) Remove the spring and totally empty
the oil
6) Fill oil up to the level indicated in
figure (with fork compressed in the fully
compressed posistion)
7) Reassemble the spring and extend fork
leg
8) Screw the plug B
Note: Note:
Note: Note: Note:
For all changes, follow the instructions
given on the chart on pag. 66, using the
Iubricants recommended on pag. 49.
Check regularly and clean thoroughly
removing any dirt on dust cover and also
check the rubber seal to ensure a good
seal.
Note: Note: Note: Note: Note:
For screw A: torque wrench setting
7,8 : 9,1 Nm.
Oil
level
57
3
GB