Adjustement Of Idling Speed; Adjustement Of Gas Clearance; Adjustement Air; Check And Adjustement Of Steering Gear - Beta EVO 2T Serie Manual De Instrucciones

ADJUSTMENT OF IDLING SPEED ADJUSTMENT OF IDLING SPEED ADJUSTMENT OF IDLING SPEED
ADJUSTMENT OF IDLING SPEED ADJUSTMENT OF IDLING SPEED
In order to correctly perform this operation
, we advise you to do it when the engine is
hot, connecting an electric revolution coun-
ter to the spark plug wire. Use the register
A A A A A to calibrate the minimum (1000 rpm).
ADJUSTMENT OF GAS CLEARANCE ADJUSTMENT OF GAS CLEARANCE ADJUSTMENT OF GAS CLEARANCE
ADJUSTMENT OF GAS CLEARANCE ADJUSTMENT OF GAS CLEARANCE
Whenever the accelerator shows
unloaded travel exceeding 3 mm,
measured from the edge of the handle,
you should adjust it by means of
cable gas register.
ADJUSTMENT AIR ADJUSTMENT AIR ADJUSTMENT AIR
ADJUSTMENT AIR ADJUSTMENT AIR
From all closed recommend to 1 1/2 turns
(B).
CHECK AND ADJUSTMENT OF CHECK AND ADJUSTMENT OF CHECK AND ADJUSTMENT OF
CHECK AND ADJUSTMENT OF CHECK AND ADJUSTMENT OF
STEERING GEAR STEERING GEAR
STEERING GEAR STEERING GEAR STEERING GEAR
Periodically check the play in the steering
sleeve by moving the fork back and forth
as shown in the figure. Whenever you feel
play, adjust as described below:
•Remove the handlbar protection
•Unscrew the 2 screws C C C C C
•Remove handlebar D D D D D
•Loosen nut E E E E E
•Loosen the screws G G G G G
•Take up the play by means of ring nut F F F F F .
•Correct adjustement, in order to not
leaving any play, should not cause diffi-
culty or irregularity in turning the handelbar
•Tighten the nut E E E E E
For reassembing proceed in the reverse or-
der.
69
4
GB