Beta EVO 2T Serie Manual De Instrucciones página 60

SP SPARK PL SP SP ARK PLUG ARK PL ARK PL UG UG UG
SP ARK PL UG
Keeping the spark plug in good condition reduce fuel consumption and increase
engine performance.
To perform the check, simply slide off the electrical connection tube and unscrew
the spark plug.
Examine the distance between the electrodes with a feeler. This distance should be
from 0.5 to 0.6 mm. If it is not, it may be corrected by bending the earth electrode.
Check as weII that there are no cracks in the insulation or corroded electrodes. If
so, replace immediately.
Observe the chart on page 66 when performing the check. Observe the chart on page 66 when performing the check. Observe the chart on page 66 when performing the check. Observe the chart on page 66 when performing the check. Observe the chart on page 66 when performing the check.
When replacing the spark plug, screw it in by hand until it stops, then tight with a
wrench.
Note: Note: Note: Note: Note:
•The use of Iow-quality oil will cause an increase in carbon deposits. We therefore
advise the use of BARDHAL KXT oil.
•Always use NGK BR7ES spark plugs.
GENERA GENERA GENERAT T T T T OR (IGNITION GENERA GENERA GENERA OR (IGNITION GENERA OR (IGNITION GENERA OR (IGNITION GENERAT T T T T OR CHECK) OR (IGNITION GENERA
Check must be performed with a component temperature of about 20°C.
Check can also be performed with the generator mounted on the motor bike or on
the engine.
Unplug the black 12 pins connector between the generator and CDI.
Verify with a multimeter that the resistance values among the below indicated pins
are in the prescribed range:
• black- white (Pick-Up)
• red-blue (capacitor charge)
• yellow-brown (services supply)
OR CHECK) OR CHECK) OR CHECK) OR CHECK)
320 ohm ± 15%
300 ohm ± 15 %
0,45 ohm ± 20%
59
3
GB