Changing Settings; Balance Settings; Span Calibration; Calibration Menu - OHAUS Adventurer SL Serie Manual De Instrucciones

EN-16

3.4.3 Changing Settings

Settings may be changed by performing the following steps:
ENTER THE MENU
With the balance turned off, press and hold Yes until MENU appears on the display.
Release the button to display Calibrate (CAL) on the first level of the Menu (See
Section. 3.4.1 Menu Structure). Each Menu Item on this level represents a Sub-
menu.
SELECT A SUB-MENU
To select the displayed Sub-menu and show the first Menu item, press Yes. To move
to the next Sub-menu item, press No.
SELECT A MENU ITEM
To select the displayed Menu item and show the Setting, press Yes. To move to the
next Menu item, press No.
SELECT THE SETTING
To select the displayed Setting, press Yes. To move to the next Setting, press No.
EXITING THE MENU
When END Sub-menu is displayed, press Yes.
Note: Press and hold No at any time to exit quickly.

3.5 Balance Settings

Refer to Section 3.4 (above) for information on navigating the Menu.
3.5.1Calibration Sub-menu
The Calibration Sub-menu is used to calibrate the balance for accurate weighing.
Adventurer SL balances may be calibrated in two ways: Span Calibration or Linearity
Calibration.

3.5.1.1 Span Calibration

Span Calibration is the basic method used to set the balance's weighing range
using two weight values: zero and a weight between 50% and 100% of the capacity
of the balance. Span Calibration is required before the balance is used the first time,
and every time the balance is moved to a new location.
To perform Span Calibration:
With the balance turned off, press and hold On
until MENU is displayed, then release the button.
CAL is displayed. Press Yes to enter the
Calibration Sub-menu.
Adventurer SL