Assembly Of Models As64, As214, As313 - OHAUS Adventurer SL Serie Manual De Instrucciones

Adventurer SL

2.2.2 Assembly of Models AS64, AS214, AS313

1.Insert the Platform Assembly on the Mounting Cone in the center of the
balance.
2.Carefully remove each of the five (5) glass Draft Shield sections from its
packing. You will note that two (2) of these are plain, two (2) contain
handles, and the other is set in a plastic frame. These sections or panels
comprise the front and rear, side doors, and top (respectively) of the Draft
Shield. The Draft Shield contains four (4) upright posts and two (2) cross-
members which act as a framework for insertion of the panels.
3.Install the plain glass panels to form the front and rear of the Draft Shield.
• Select a plain glass panel and insert the bottom edge of the glass in the
recessed slot in front of the balance, as shown.
• As you push the top edge of the glass panel toward the cross-member,
reach inside the top of the framework and depress the small clip located
under the cross-member.
• Press the glass panel into the framework until you feel the glass slip into
place.
• Release the clip when the glass panel is fully inserted.
• Repeat these steps to install the other plain glass panel on the opposite
side of the framework.
Clip Locations
Glass Front Panel
Close-up of Clip
Platform Assembly
Glass Rear Panel
Mounting Cone
Recessed Slot
EN-5