Parts Included; Part Number Qty - Balanced Body Allegro Manual Del Usuario

How to Install the Allegro

PARTS INCLUDED:

Part Number Qty Description
GEN9021 4 Nylock hex nuts
GEN9472 4 1⁄4"–20 x 3⁄4" button head Allen
screws
GEN9222 16 5⁄16"–18 x 3⁄4" button head Allen
screws
GEN9280 1 Large Allen wrench (3⁄16")
GEN9282 1 Small Allen wrench (5⁄32")
GEN9235 2 1 - 1⁄4" long silver screws
ALL0160 2 Black shoulder posts
ALL0091 4 Leg pads
614-020 2 Transport wheel brackets
GEN9162 2 Spacers (Not Shown)
N/A 4 Legs (Not shown)
(4) Nylock hex nuts
(4) 1/4" - 20 x
(2) Transport wheel brackets
3/4" button head
Allen screws
(2) Black shoulder posts (4) Leg pads
(4) Legs (not shown)
TOOLS NEEDED (NOT INCLUDED):
» Phillips screwdriver (for Allegros with serial numbers 008342
» Ratchet and 1⁄2" socket (for Allegros with serial numbers
» Large flat head screwdriver
» Two 1⁄2" wrenches
» 7⁄16" wrench
TURN THE ALLEGRO UPSIDE DOWN
1. Attach all springs to keep the carriage stationary. Remove
(2) 1 - 1/4" long
silver screws
INSTALL THE LEGS
2. If you have an Allegro with serial number 008342 or lower,
(1) Large
(1) Small
Allen
Allen
wrench
wrench
(3/16")
(5/32")
(16) 5/16" - 18 x 3/4"
button head Allen screws
3. Place one of the legs onto the frame, aligning the four holes
Legs Kit
®
and lower)
above 008342)
ropes, shoulder rests, and risers. Place the footbar in its
highest position and check that all pins are locked so that the
footbar is secure. Then, with the help of a strong friend, lift
the Allegro from both ends and carefully turn it upside down
and set it on the floor. You may want to place a pad or other
floor protection beneath the Reformer.
use the Phillips screwdriver to remove the screws holding the
four rubber feet to the bottom of the Allegro. If you have an
Allegro with a serial number higher than 008342, use the
ratchet and 1/2" socket to remove these screws. If you have an
Allegro with a serial number higher than 014195, the foot can
be removed by hand. Grasp the foot firmly and turn counter-
clockwise.
in the leg with the brass colored inserts visible at each corner
of the frame. Using the 3/4" long button head allen screws,
fasten each leg to the frame. (Tip - using your fingers, thread
a screw into each of the holes before you begin to tighten any
of them.) Tighten the screws using the provided large Allen
wrench. When all four legs are tightened, peel the backing off
the leg pads and stick them to the bottom of each leg.
19