Signature Kitchen Suite SKSFD3604P Manual Del Propietário página 33

Application Guidelines/Water Supply
Parameters
Service Flow
Community or Private Well -
Water Supply
Water
20 – 120 psi (138 – 827 kPa)
Pressure
Water
33 °F – 100 °F (0.6 °C – 37.8 °C)
Temperature
Capacity 200 gallons (757 liters)
It is essential that the manufacturer's recommended
installation, maintenance and filter replacement
requirements be carried out for the product to perform
as advertised.
NOTE
While the testing was performed under standard
laboratory conditions, actual performance may vary.
Replacement Cartridge: LT1000P-S
For replacement filters, visit your local dealer or
distributor or search under "water filters" on the
For further assistance, the SIGNATURE KITCHEN
SUITE Customer Information Center is open 24 hours
a day/7 days a week.
USA : 1-855-790-6655
NSF is trademark of NSF.
0.5 gpm (1.89 lpm)
Potable Water
website.
WARNING
Do not allow children under 3 years of age to
have access to small parts during the installation
of this product.
To reduce the risk associated with the
Do not use with water that is microbiologically
unsafe or of unknown quality without adequate
disinfection before or after the system. Systems
cysts. EPA Establishment # 070595-MEX-001
CAUTION
To reduce the risk associated with property
Read and follow Use Instructions before
installation and use of this system.
Installation and use MUST comply with all state
and local plumbing codes.
Do not install if water pressure exceeds 120 psi
(827 kPa). If your water pressure exceeds 80
psi, you must install a pressure limiting valve.
Contact a plumber if uncertain how to check your
water pressure.
Do not install where water hammer conditions
may occur. If water hammer conditions exist you
must install a water hammer arrester. Contact a
plumbing professional if you are uncertain how
to check for this condition.
Do not install on hot water supply lines. The
maximum operating water temperature of this
temperatures drop below 40 °F (4.4 °C).
every 6 months, at the rated capacity or if a
when temperatures are expected to drop below
33 °F.
Do not install systems in areas where ambient
temperatures may go above 110° F (43.3 °C).
on a water system, a device for controlling
pressure due to thermal expansion must be
installed.
of leaks.
MAINTENANCE 33