Signature Kitchen Suite SKSFD3604P Manual Del Propietário página 7

CAUTION
INSTALLATION
Do not install the refrigerator where there may be a danger of the unit falling.
The refrigerator must be properly installed in accordance with the Installation Instructions.
OPERATION
Do not use aerosols near the refrigerator.
This appliance is intended to be used only in domestic and similar applications.
Do not strike or apply excessive force to any glass surface. Do not touch glass surfaces if they are cracked
or broken.
injury if items are removed with excessive force.
MAINTENANCE
Do not use strong detergents like wax or thinners for cleaning. Clean with a soft cloth.
Remove foreign objects (such as dust and water) from the prongs of the power plug and contact areas. Do
not use a wet or damp cloth when cleaning the plug.
Do not spray water directly on the inside or outside of the refrigerator.
Do not clean glass shelves or covers with warm water when they are cold. They may break if exposed to
sudden temperature changes.
WARNING
Keep ventilation openings, in the appliance enclosure or in the built-in structure, clear of obstruction.
Do not use mechanical devices or other means to accelerate the defrosting process, other than those
recommended by the manufacturer.
Do not damage the refrigerant circuit.
Do not use electrical appliances inside the food storage compartments of the appliance, unless they are of
the type recommended by the manufacturer.
The refrigerant and insulation blowing gas used in the appliance require special disposal procedures. When
This appliance contains a small amount of isobutane refrigerant (R600a), a natural gas with high
environmental compatibility which it is also combustible. When transporting and installing the appliance,
care should be taken to ensure that no parts of the refrigerating circuit are damaged. Refrigerant squirting
out of the pipes could ignite or cause an eye injury. If a leak is detected, avoid any open flames or potential
sources of ignition and air the room in which the appliance is standing for several minutes.
In order to avoid the creation of a flammable gas air mixture if a leak in the refrigerating circuit occurs, the
size of the room in which the appliance may be sited depends on the amount of refrigerant used. The room
2
must be 1m in size for every 8g of R600a refrigerant inside the appliance. The amount of refrigerant in
your particular appliance is shown on the identification plate inside the appliance. Never start up an
appliance showing any signs of damage. If in doubt, consult your dealer.
SAVE THESE INSTRUCTIONS
SAFETY INSTRUCTIONS 7