Jungheinrich ECR 327 Instrucciones De Servicio página 72

First use
When the main switch and the switch latch (if applicable) are turned on, the LED (22)
lights up red.
When the correct operating code (factory setting 2-5-8-0) is entered, the LED (22)
lights up green.
If an incorrect code is entered, the LED (22) will flash red for two seconds. You will
then need to re-enter the code.
NOTICE In user mode, the Set key (23) has no function.
Switching off
The vehicle is switched off by pressing the
o key (27).
NOTICE The vehicle can be programmed to switch off after a predefined time. This
requires the corresponding code lock parameter to be set
(see Section 5.4)
24 25
1 2
4 5
7 8
0
Set
23
22
26
3
6
9
27
E 35