Settings; Dim Led Indicator; Decommissioning The Product; Maintenance, Cleaning, Repair - Webasto Pure II Instrucciones De Montaje

EN
u If necessary, unlock charging station with key-oper-
ated switch.
u Perform initial operation check and record measured
values in test log. An EV simulator is used for the
measurement at the charging coupling.
u Simulate and test the individual operating and protec-
tion functions with the EV simulator.
u Connect the charging cable to the vehicle.
– The LED changes from green to pulsing blue.
9

Settings

NOTE
It is necessary to complete the following procedures
within a certain time, therefore read through all the steps
before starting the procedure.
9.1

Dim LED indicator

Fig. 12
See also Key-operated switch.
ü Charging station switched on.
ü LED indicator is green.
ü Key-operated switch set to ON.
ü No vehicle connected.
u Set key-operated switch from ON to OFF, green chase
light runs from bottom to top, wait until it reaches the
bottom again.
Set key-operated switch from OFF to ON (switch to
u
ON within 3 seconds)
– Dimming mode is unlocked
The LED indicator changes to blue and dims in several
stages from maximum to minimum, in 3 second intervals.
After reaching the lowest dim level, the LED indicator
switches back to maximum. This cycle through the
brightness stages is repeated five times.
u Set key-operated switch from ON to OFF.
Dim level is selected.
NOTE
The LED is set to max. brightness at the factory.
8
NOTE
The brightness of the error colour shades cannot be
changed.
10

Decommissioning the product

A decomissioning shall be carried out only by an electri-
cian.
u Disconnect the power supply.
u Electrically disconnect the charging station.
u Disposal: see chapter 13, "Disposal" on page 8.
11

Maintenance, cleaning, repair

Maintenance

11.1
Maintenance must only be carried out by an electrician
and in accordance with local requirements.
11.2

Cleaning

DANGER
High voltages.
Danger of fatal electric shock. Do not clean the charging
station with a high-pressure cleaner or similar device.
u Clean the installation only with a dry cloth. Do not use
aggressive cleaning agents, wax or solvents.
11.3

Repair

Unauthorised repair of the charging station is not permit-
ted.
Webasto reserves the exclusive right to perform repairs to
the charging station. It is only permitted for repairs to be
carried out by an electrician using original spare parts
sold by Webasto.

To replace the charging cable

12
DANGER
Danger of fatal electric shock.
Switch off and secure the power supply to the
u
charging station.
NOTE
Only use genuine Webasto parts.
NOTE
The charging cable may be replaced a maximum of four
times during the service lifetime of the Webasto Pure.
NOTE
Refer to the Webasto online shop for part numbers:
www.webasto-charging.com
Follow the installation instructions provided with the re-
pair kit when replacing the charging cable.

Disposal

13
The symbol of the crossed-out waste bin indicates
that this electrical/electronic device must not be
disposed of in household waste at the end of its
service life. Dispose of the device free of charge at
a local collection point for electrical/electronic
devices. Addressed can be obtained from your city
or local authority. Separate collection of electrical
and electronic devices enables re-use, material re-
cycling or other forms of re-utilisation of waste
equipment while also avoiding the negative effects
of hazardous substances which may be contained
in the devices on the environment and for human
health.
u Dispose of packaging in corresponding recycling con-
tainer in accordance with national regulations.
14

Declaration of conformity

The Webasto Pure has been developed, produced, tested
and supplied in accordance with the applicable legal reg-
ulations of the specified sales regions.
The complete text of the EU-declaration of conformity is
available on the download area of http://webasto-
charging.com/.
OI II Webasto Pure