First Setup - Diono Radian 3 RXT Manual De Instrucciones

FIRST SETUP

UNFOLDING AND FOLDING
1. Place car seat on its back on a flat surface and
unfasten red carry strap from the bottom. Be sure
the harness adjuster moves freely and is not locked
within the bottom of the seat.
2. Rotate bottom until your hear
it "click", this confirms the car
seat is locked for use.
3. Check proper operation — Pull
harness adjusting strap until
harness begins to tighten. If it
does not tighten freely, check the belt path on the
back of the seat bottom is clear from obstruction. To
fold seat, release the levers as shown and repeat
the above steps in reverse.
4. Tuck the red strap through the harness slot and
store behind the cover.
5. To fold, push lever shown and secure with red strap.
26
1-855-463-4666
1. Place your child in the seat. Make sure their back
2. Place harness straps over child's shoulders and
CLICK!
folding/
release
lever
3. Be sure the harness straps are at the proper
US & CA EN
is flat against the car seat back (this can be done
in or out of the car). Avoid bulky or heavy clothing
because they will prevent the harness straps from
being tightened properly at first fitment.
legs and buckle. You will hear a "click" when
buckle tongues are securely attached. Pull up on
each buckle tongue to make sure it is securely
attached.
height. Rear-Facing: Harness straps MUST be at or
just below the child's shoulders. Top of head must
be 1.5 in. below the top of the car seat shell.
Rear-Facing
(harness AT or just below shoulders)
diono.com
HARNESS SETUP
27