Diono Radian 3 RXT Manual De Instrucciones página 20

INSTALL USING 5-POINT HARNESS WITH:
LAP BELT: 5–50 lb (2.3–22.7 kg)
1. Place car seat rear-facing in
back seat of the vehicle with
detachable rear-facing base
installed (page 32). The entire
seat bottom should sit flat on
the vehicle seat.
2. Slide the vehicle seat belt
through the rear-facing belt
path and out the other side.
Buckle it. The seat belt should
lie flat and not be twisted.
38
1-855-463-4666
3. Tighten the vehicle seat belt.
4. Test for tightness.
1
2
Press down firmly in the center
of the car seat. To tighten, pull
on the loose end of the vehicle
lap belt to tighten it.
Grab the side of the seat where
the vehicle seat belt is and
slide the car seat side-to-side
and front-to-back. If the seat
moves less than 1 in. (2.5 cm),
it is tight enough. Do not test
by grasping the top or back of
the seat.
diono.com
3
4
39