Diono Radian 3 RXT Manual De Instrucciones página 19

INSTALL USING LAP/SHOULDER BELT WITH
5-POINT HARNESS : 5–50 lb (2.3–22.7 kg)
1. Place car seat rear-facing in
back seat of the vehicle with
detachable rear-facing base
installed (page 32).
The entire seat bottom should
sit flat on the vehicle seat.
2. Slide the vehicle seat belt
through the rear-facing belt
path and out the other side.
Buckle it. The seat belt should
lie flat and not be twisted.
36
1-855-463-4666
3. IMPORTANT!
4. Test for tightness.
1
2
Tighten the
vehicle seat belt.
Press down firmly in the
center of the car seat. To
tighten, pull on the loose end
of the vehicle lap/shoulder
belt.
Grab the side of the seat
where the vehicle seat belt is
and slide the car seat side-
to-side and front-to-back. If
the seat moves less than 1 in.
(2.5 cm), it is tight enough. Do
not test by grasping the top or
back of the seat.
diono.com
3
4
37