Diono Radian 3 RXT Manual De Instrucciones página 18

5. Place car seat rear-facing
in back seat of the vehicle.
Center the car seat between
the vehicle LATCH anchors.
The entire seat bottom should
sit flat on the vehicle seat.
6. Slide the LATCH strap through
the rear-facing belt path and
out the other side.
The LATCH strap should lie flat
and not be twisted.
7. Attach LATCH connectors
to vehicle LATCH anchors
and listen for audible click to
confirm engagement.
34
1-855-463-4666
8. Tighten the LATCH strap.
5
9. Test for tightness.
6
10. To remove LATCH strap from
7
Press down firmly in the center
of the car seat while tightening
the LATCH strap. You may
need to tighten further by
pulling upwards in-line with
the belt path as shown.
Grab the side of the seat with
one hand where the LATCH
strap is and slide the car
seat side-to-side and front-
to-back. If the seat moves
less than 1 in. (2.5 cm), it is
tight enough. Do not test by
grasping the top or back of the
seat.
vehicle — Use LATCH release
on the LATCH connectors and
pull them off the anchor bars.
diono.com
8
9
10
35