Adjusting Headrest - Diono Radian 3 RXT Manual De Instrucciones

LAP BELT CUSHION
For forward-facing installations using a
with NO top tether available from 22–65 lb (10–29.5 kg).
DO NOT USE REAR-FACING.
1. Remove the center buckle pad by
pulling it carefully up and over the
buckle.
2. Unclip seat cover from seat
bottom. Lift seat cover away from
the seat bottom and remove the
buckle.
3. Place lap belt cushion on seat
bottom, and slide the buckle
through the slot in the cushion
that matches the slot position
being used on the seat.
4. Guide buckle through seat cover
bottom and memory foam cushion.
Reattach cover to seat bottom.
5. Reinstall the center buckle pad.
Should you need a longer buckle,
these are available by calling Customer Care.
60
1-855-463-4666
IMPORTANT:
LAP BELT ONLY
slot, the headrest may now be used at its lowest
position.
1. Carefully unfasten the fabric panels by detaching
2. Position hand as shown, tilt
1
3. Carefully re-fasten the fabric panels.
2
4. To lower the headrest, follow the steps above but
3

ADJUSTING HEADREST

When your child fits at the third harness
the fabric fasteners located on the upper sides and
beneath the headrest.
the top of the headrest slightly
towards you and slide upwards.
NOTE:
You might need two
hands.
slide the headrest downwards.
diono.com
61