Changing Harness Position - Diono Radian 3 RXT Manual De Instrucciones

Convertible todo en uno, desde el nacimiento hasta las, 120 lb / 54 kg
Ocultar thumbs Ver también para Radian 3 RXT:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

CHANGING HARNESS POSITION

1. Loosen the harness straps. Lift up on the harness
release lever while pulling out on the harness straps
at the chest clip. Unbuckle the chest clip. Detach
the buckle tongues from the center buckle.
2. Detach harness straps from metal plate on back
of seat. Pull each harness through to the front of
the seat. Re-locate each harness to the correct slot
determined, push through to the back of the seat
taking care to keep each harness strap flat. Re-
secure the harness straps to the metal plate. Check
to ensure harness loops are properly secured to
the metal plate.
3. Check the center buckle position. When rear-
facing, the correct slot is the one that is closest to
your child without being underneath your child.
When forward-facing, children 22–30 lb (10–13.6
kg) MUST use the middle buckle slot only. Children
above 30 lb (13.6 kg) MUST use the forward most
buckle slot only.
4. To adjust center buckle strap — Remove all lower
seat cover clips. Reach into the rear-facing belt
path. You will feel the buckle strap metal retainer.
56
1-855-463-4666
CHANGING HARNESS POSITION
5. Rotate metal retainer and insert it up through the
shell and pad. From the top of the car seat, pull the
buckle strap out.
6. Insert metal retainer in the new buckle slot
position. Reach underneath the car seat and pull
the metal retainer through.
SECURING YOUR CHILD
1. Pull up on center buckle strap to make sure it is
secured.
2. Pull all the slack out from around the waist. Pull
up on the harness strap while pushing the chest
clip down. Do this to both sides.
3. Tighten the harness by pulling the harness
adjustment strap. When you are not able to
pin. any of the harness webbing at your child's
shoulder, the harness is tight enough. A snug
harness should not allow any slack. It lies in a
relatively straight line without sagging. It does not
press on the child's flesh or push the child's body
into an unnatural position.
4. Buckle the chest clip. You will hear a "click" when
the chest clip is securely buckled.
5. Place the chest clip at armpit level.
diono.com
57

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido