Publicidad
Idiomas disponibles
Idiomas disponibles
Parameter programming of switching module Art. 6935/A
The following parameters can be programmed by using the PRG and SHIFT push-buttons and the following procedure:
Shift
Figure 2. Planimetry components of the push-button area
- Carry out the jumper CN3 only in programming mode and then set it in the previous function (remove, if present, the card
connected to connector "PROGRAM").
- Press PRG and Shift, release PRG keeping pressed SHIFT until the LED DL1 (close to the "PROGRAM" conenctor) flashes
then release also the SHIFT push-button.
- Fo the lock activation time and other three auxiliary functions press the respective push-button on the keypad of interphone
type 6221, see table 1.
- There is a change of the led flashing frequency to signal the command reception.
- Enter the desired value on the keypad of interphone type 6221 and press push-button "INVIO" (enter).
- If the programming has been carried out correctly, the led remains switched on with steady light, if it continues to flash ,
repeat the procedure from the beginning. The procedure must be repeated any time you want to modify a parameter.
- Replace the card (if before it was present) connected to the "PROGRAM" connector.
TABLE 1
Parameter
Answer time dwell for the panel call
Comversation time
for the panel call (*)
Answer time dwell for the interphone call
Conversation time dwell
for the interphone call (*)
Selfactivation time
Activation time
for S1 function
Activation time
for LS function
Activation time
for F1 function
Activation time
for F2 function
(*) for this parameters the real value must be multiplied by 10 (digiting 2 we mean 20 seconds). Therefore the minimum, maxi-
mum and default values are 10, 990 and 60 seconds repectively
For example: programming of the conversation time dwell from the interphone with 90 sec. value.
After setting the switching module on the programming mode press push-button 4 of interphone type 6221, release it and press
the "INVIO" (enter) push-button.
After the change of the flashing frequency of LED DL1 on the switching module, press push-button 9 of interphone and then
press "INVIO" (enter) push-button.
Check that the DL1 led is switched on with steady light.
Command from interphone 6221
1 + INVIO (enter)
2 + INVIO (enter)
3 + INVIO (enter)
4 + INVIO (enter)
5 + INVIO (enter)
LED
Program
CN3
Min Value
Max Value
10
60
1
99
10
30
1
99
5
30
1
120
1
120
1
120
1
120
Not short-circuited
(normal condition)
S h o r t - c i r c u i t e d
(Programming start)
Default Value
30
6
20
18
20
1
1
1
1
9
Publicidad
