Harbor Breeze 41239 Manual Del Usuario página 11

FINAL INSTALLATION
4 . Partially insert the blade screws (BB) along with the
blade washers (CC) through the blade (J) and into
the blade arm (I) . Tighten each blade screw (BB) with
a Phillips screwdriver, starting with the one in the
middle . Repeat this step for the remaining blades (J)
and blade arms (I) .
Hardware Used
BB
Blade Screw
CC
Blade Washer
5 . Install the blade arm (I) to the underside of the motor
(E) with motor screws (L) previously removed (Step 3,
page 10) . Tighten with Phillips screwdriver .
Repeat for each blade arm (I) .
6. Remove the fitter plate screws (N) preassembled
to the fitter plate (F). Then, connect the single-pin
connectors from the fitter plate (F) and the light kit
(G) -- blue to black and white to white .
4
x 15
x 15
5
6
Single-pin
Connectors
11
BB
CC
I
E
L
I
N F
G
J